Internship EHS Specialist resume example

• Under supervision, walked the work area with operators to identify exposure and energy-isolation hazards, checked the selected controls during the task, and followed training gaps through supervisor confirmation.
• The team updated distribution-center risk assessments with operations after an equipment layout change, checking chemical inventory and current SDS records against observed work areas; I supported research preparation, validation, and documentation under mentor review. The team assigned owners to missing records and unresolved hazards before the next readiness review; confirmed with my mentor that my contribution was limited to the assigned support and validation work.
• The team reworked EHS training for receiving and warehouse teams around site-specific scenarios, documenting attendance, knowledge checks, and follow-up corrective actions; I supported research preparation, validation, and documentation under mentor review. The team separated course completion from demonstrated understanding when planning refresher sessions; confirmed with my mentor that my contribution was limited to the assigned support and validation work.
• Under supervision, owned an EHS risk-assessment follow-up using SDS and permit requirements, resolved missing chemical controls and completed corrective-action evidence before area reopening.
• Under supervision, published EHS training using observed maintenance hazards, reduced overdue safety actions by 27% and verified environmental controls with the responsible site specialist.

• In a mentor-reviewed simulation, updated distribution-center risk assessments with operations after an equipment layout change, checking chemical inventory and current SDS records against observed work areas; assigned owners to missing records and unresolved hazards before the next readiness review.
• As a second supervised exercise, reworked EHS training for receiving and warehouse teams around site-specific scenarios, documenting attendance, knowledge checks, and follow-up corrective actions; separated course completion from demonstrated understanding when planning refresher sessions.
• Within a supervisor-assigned documentation task, coordinated emergency-plan document reviews and updated site contact and responsibility records. gave shift leaders a current reviewed version instead of conflicting local copies.
• Used Risk assessments and Site inspections to compare the source record with the proposed result; documented exceptions, the reviewer, and the acceptance decision before handoff.
• Built a training inspection sheet from public specifications and synthetic measurement results; separated instrument variation from an out-of-tolerance condition and kept the measurement method beside each reading.
• Compared a proposed process change with the original setup, documented the drawing or instruction revision affected, and wrote an acceptance checklist that required repeatable evidence before recommending release.
• Owned the bench validation using the original failure conditions, resolved a specification mismatch and completed a traceable test record with calibrated measurement references.

Relevant coursework: Water treatment, environmental chemistry, air pollution control, hazardous waste management

Risk assessments · SDS · EHS training · Incident investigation · Corrective actions

• Published an independent engineering note using the training test record, explaining tolerance, measurement uncertainty and why a passed bench test is not a production qualification.